FLUX REMOVER
User Instructions

Inland Flux Remover is specifically designed to remove cutting and soldering residue from your copper foiled and leaded glass pieces prior to waxing or applying patina. You can also use it to clean your glass after applying patina without affecting the patina finish.

Safety

1. Avoid eye contact
2. KEEP OUT OF THE REACH OF CHILDREN.
3. Do not freeze, store in a cool place.
4. Refer to MSDS for additional information

Instructions

1. Pour a liberal amount of Flux Remover to your piece.
2. Work Flux Remover over entire piece using a wet cloth, sponge or soft bristle brush paying particular attention to seams and corners.
3. Rinse thoroughly under warm running water.
4. Dry piece before applying wax or patina.
5. Use same procedure to clean patina residues.

Service

If you have any questions or comments regarding the use of this or any Inland product please call Inland Customer Service at 1-800-521-8428 9 AM to 5 PM EST. or write us at:

Inland Craft Products, Co.
32052 Edward Dr.
Madison Heights, MI 48071 USA

Return to Archive Index | Return to User Guide Index

If you don't see the navigation bar at the top of your screen, click on the above logo.