EASYMARK ENGRAVER™
User Instructions
Operating Instructions
- Make sure the engraving diamond tip is securely fastened in the chuck before plugging adapter into electrical receptacle.
- Make sure that the power connection from the engraver to the top of the adapter cord is lined properly: + to + and Θ to Θ.
- Turn switch to "ON".
- Hold the engraver like a pen and apply minimal pressure--allow the diamond to do the work. Applying too much force will cause the diamond tip to rotate at a slower speed and work less effectively.
- All diamond tools last longer if you keep the abrasive surface and the material being worked wet. This has the added benefit of greatly reducing the danger of breathing debris.
Changing
Diamond Tips
- Unplug the EasyMark™ Glass Engraver.
- Use pliers to grasp and pull the diamond tip straight out.
- Insert new diamond tip into the chuck making sure it seats fully down into the chuck.
- 20 Piece Diamond Tip Set: Inland no. 50115
- Standard Ball Tip: Inland no. 50107.
- Large Ball Tip: Inland no 50110
- Cone Tip: Inland no. 50111
- Inverted Cone Tip: Inland no. 50112
Service
If you have any questions or comments regarding the use of this or any Inland product please call Inland Customer Service at 1-800-521-8428 9 AM to 5 PM EST., email us, or write us at:
|
|
Inland Craft Products, Co. 32052 Edward Madison Heights, MI 48071 |
Document No. 3000/QF/633 |
| If you don't see the navigation bar at the top of your screen, click on the above logo. | ||