MATERIAL SAFETY DATA SHEET
INLAND CEMENT SYSTEM
INLAND CRAFT PRODUCTS, CO.
FSC: 8040
NIIM: 00F012888
DOT: UN1299
Manufacturer's CAGE: INLAN
Part No. Indicator: A
Chemical Name and Synonyms: Inland Cement System
Part Number/Trade Name: 50031-50036/Inland Cement System
Chemical Family: See Below
SECTION I - GENERAL INFORMATION
Manufacturer's Name: Inland Craft Products, Co.
Manufacturer's Street: 32052 Edward
Manufacturer's City: Madison Heights
Manufacturer's State: Michigan
Manufacturer's Zip: 48071
Manufacturer's Emergency Phone: 1-248-583-7150
Manufacturer's Phone: 1-248-583-7150
Date Prepared: 04-23-2008
SECTION II - INGREDIENTS
Proprietary: YES
Ingredient: PROPRIETARY
Paints, Preservatives and Solvents:
- Pigments: N/A
- Catalyst: N/A
- Vehicle: N/A
- Solvents: N/A
- Additives: N/A
- Others: N/A
- Base Metal: N/A
- Alloys: N/A
- Metallic Coatings: N/A
- Filler Metal Plus Coating or Core Flux: N/A
- Other: N/A
SECTION III - PHYSICAL DATA
|
Component: |
Turpentine (Terpene) C10H16 |
Boiled Linseed Oil |
| Boiling Point (º F): | 311-338 | Not known |
| Vapor Pressure (mm Hg.): | @20º C = 4mm | Not known |
| Vapor Density (AIR=1): | 4.7 | Not known |
| Specific Gravity (Water=1): | 0.863 | 0.9 |
| Percent Volatile by Volume (%): | 99+ | Less than 1% |
| Evaporation Rate (Butyl Acetate=1): | <1.0 | Not known |
| Solubility in Water (g/L @20ºC) | Negligible | Less than 50 |
| Appearance and Odor: | Colorless liquid with pine like odor | Pale amber, hazy, viscous liquid, characteristic odor |
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
| Component |
Turpentine (Terpene) C10H16 |
Boiled Linseed Oil |
| Flash Point (Method Used): | 107.6 ºF TCC | 410°F |
| Flammable Limits: | N/A | not known |
| Lower Explosion Limits | 0.8% | Not known |
| Auto Ignition Temperature | Not Known |
Extinguishing Media: Dry Chemical or Carbon Dioxide for small fire; use foam or water spray for large fires
Special Fire Fighting Procedures: Same as for other hydrocarbons. Wear self contained breathing apparatus. Closed containers may explode when exposed to extreme heat. Isolate from heat, electrical equipment, sparks and open flame.
Unusual Fire and Explosion Hazards: Hazard of autoignition / spontaneous combustion
Other Information: Keep container closed, upright when not in use. Store in cool, dry, well ventilated area. Do not allow to freeze.
SECTION V - HEALTH HAZARD DATA
Threshold Limit Value: 100 PPM; 560 mg/cubic meter
Effects of Overexposure: Headaches, dizziness, nausea
Skin: Irritating to skin upon repeated or
prolonged contact.
Swallowed: Can be harmful if swallowed.
Emergency First Aid Procedures:
- Eye: Flush with water for 15 minutes, call physician
- Skin: Remove clothing, wash with soap and water
- Inhalation: Remove victim from contaminated area
- Ingestion: Do not induce vomiting. Call a physician immediately
SECTION VI - REACTIVITY DATA
Stability: Stable
Conditions to avoid: Heat, open flame, arcs or sparks
Incompatibility (Materials to avoid):
Hazardous Decomposition Products:
Hazardous Polymerization: Will not occur
SECTION VII - SPILL OR LEAK PROCEDURES
Steps to be taken in Case Material is Released or Spilled: No smoking. Flush area with water. If spill is large enough, put into salvage tank
Waste Disposal Method: Incinerate in open furnace, as hydrocarbon would be handled
SECTION VIII - SPECIAL PROTECTION INFORMATION
Respiratory Protection (Specify Type): For high vapor concentration, use air line mask
Ventilation:
- Local Exhaust:
- Special:
- Mechanical (General):
- Other:
Eye Protection: Chemical Safety Goggles
Other Protective Equipment: N/A
SECTION IX - SPECIAL PRECAUTIONS
Precautions for Handling and Storing:
"Combustible! Keep away from open flame."
Other Precautions: Hazard of of autoignition / spontaneous combustion
If you don't see the navigation bar at the top of the screen, click on the Inland logo above.